Search found 21 matches

by retiredtech
Tue Jul 02, 2019 4:51 pm
Forum: Meetinghouse Audio
Topic: Problems with Williams Sound PPA T27 Transmitter
Replies: 7
Views: 793

Re: Problems with Williams Sound PPA T27 Transmitter

OK, here is the answer. Go to the williams sound web site and look at their antennas for the T27. A coaxial dipole antenna at 80" should give significant gain to the T27 transmitter. Here is their url: https://www.williamssound.com/accessories.

Richard True STS
by retiredtech
Tue Jul 02, 2019 2:18 pm
Forum: Meetinghouse Audio
Topic: Problems with Williams Sound PPA T27 Transmitter
Replies: 7
Views: 793

Re: Problems with Williams Sound PPA T27 Transmitter

I understand the specs on the transmitters and the tighter limits specified by the FCC. I assume these specs, 80mV/m @3m, would apply to the output design setting of the RF amplifier in the transmitter. So if I put a higher gain antenna on the transmitter and increase the ERP would I still be in spe...
by retiredtech
Tue Jul 02, 2019 10:45 am
Forum: Meetinghouse Audio
Topic: Problems with Williams Sound PPA T27 Transmitter
Replies: 7
Views: 793

Re: Problems with Williams Sound PPA T27 Transmitter

First, there is nothing wrong with the antenna. Both check out ok. I decided to move to another building in the stake and obtain another T27 transmitter for comparison....... Set up another test with equipment and RF Field Strength meter at 20' apart. Set the FS reading at 266 with no RF from any of...
by retiredtech
Mon Jul 01, 2019 3:37 pm
Forum: Meetinghouse Audio
Topic: Problems with Williams Sound PPA T27 Transmitter
Replies: 7
Views: 793

Problems with Williams Sound PPA T27 Transmitter

We have had the Williams Sound model PPA T17 wireless listening device for over 15 years and recently received the newer T27 model. At our recent stake conference I received numerous complaints that the signal was breaking up, especially at a distance of around 120 feet. We never had any issue with ...
by retiredtech
Wed May 30, 2018 7:08 pm
Forum: Webcasting
Topic: Alternative to Webcasting using a bridge
Replies: 9
Views: 2085

Re: Alternative to Webcasting using a bridge

We have decided not to use the bridge between the 2 buildings this stake conference and go with the Web Cast environment. The previous use from the last stake conference was not entirely satisfactory. That HDMI extender looks very promising and am anxious to try that out on our next conference. Of c...
by retiredtech
Wed Dec 27, 2017 1:47 pm
Forum: Webcasting
Topic: Alternative to Webcasting using a bridge
Replies: 9
Views: 2085

Re: Alternative to Webcasting using a bridge

You are correct - I was not thinking! Those devices just use the cat5 or any other cable to handle their data flow and no IP layers are involved. At this point, as an STS, I think I will back away from this situation and let higher levels decide on what to do, perhaps even abandon the project. In th...
by retiredtech
Wed Dec 27, 2017 9:11 am
Forum: Webcasting
Topic: Alternative to Webcasting using a bridge
Replies: 9
Views: 2085

Re: Alternative to Webcasting using a bridge

Yes, thank you for your input. That was exactly my conclusion. Another option I may try, if I have the time, is 2 devices that allow HDMI to be streamed over cat6, one on each end. There are limitations on cat6 distance so that may be an issue. Total cat6 distance from the flat panels down to the se...
by retiredtech
Tue Dec 26, 2017 2:06 pm
Forum: Webcasting
Topic: Alternative to Webcasting using a bridge
Replies: 9
Views: 2085

Alternative to Webcasting using a bridge

Our stake has used webcasting between 2 buildings for the past 3 years with mixed results. Our stake president has requested an alternative to the webcasting product. The FM group then installed a 900 Mhz link between the 2 buildings using Ubiquiti flat panel products and setup as a bridge. Now we n...
by retiredtech
Tue Dec 03, 2013 3:22 pm
Forum: Meetinghouse Internet
Topic: Connectivity issues with 1041n AP
Replies: 10
Views: 2095

Connectivity issues with 1041n AP

We get complaints from users that there is poor or no connectivity in a certain part of the building and yet there is a 1041n AP right over their head. So what we have determined is that they power up their iPad etc. at one end of the building get connected to that AP and then go to the other end of...
by retiredtech
Wed Aug 28, 2013 7:56 am
Forum: iPhone/iPad Member Tools App
Topic: Release 2.2.1 on iPad removed access to Stake
Replies: 9
Views: 1071

Re: Release 2.2.1 on iPad removed access to Stake

Problem resolved! Since the "units" tab is no longer there you must first tap on the directory at the top center of the page. This then opens a drop down menu showing the rest of the wards and stake you have authority to view! So it appears there is not a problem with the new code only a c...

Go to advanced search