Search found 50 matches

by CalS201
Fri Jan 17, 2020 11:12 am
Forum: Meetinghouse Internet
Topic: Dedicated IP Addresses for Network Devices
Replies: 17
Views: 1177

Re: Dedicated IP Addresses for Network Devices

Just as a point of reference for webcasting, our stake has used Win7+encoder, and then the Teradek for the last 9 years. Additionally, we have 4 bldgs in the stake and rotate the conference origin bldg every 6 months. We have not had any transmitting problems (knock on wood). We have always used un-...
by CalS201
Fri Oct 19, 2018 8:04 am
Forum: Webcasting
Topic: Test event change
Replies: 4
Views: 932

Re: Test event change

Mikerowaved wrote:While seeing a stream of the Tabernacle Choir at Temple Square is appreciated, what I see missing is the ability to specify the bitrate of the stream to test weaker receive sites.


I concur.
by CalS201
Tue Sep 11, 2018 9:10 am
Forum: Satellite
Topic: Is the Church Satellite System capable of HD?
Replies: 21
Views: 6350

Re: Is the Church Satellite System capable of HD?

Last week I plugged HDTV into the receiver's HDMI connector and got 1080i. Image quality was better than SD. However, with a lot of movement on the screen there was some pixelation so the bitrate must be low. It would be easy to get the HDMI signal to the pulpit video jack by inserting a HDMItoSDIco...
by CalS201
Sun Jun 24, 2018 11:39 pm
Forum: Broadcasts and Conferences
Topic: Ready to smash the Teradek Vidiu; alternatives?
Replies: 40
Views: 8520

Re: Ready to smash the Teradek Vidiu; alternatives?

mawhiteley wrote: In summary, something on the stake center's network seems to conflict with these boxes, causing them to go brain dead for long periods of time. So I'm still troubleshooting..... I would highly recommend you confirm the DCHP assigned address of your laptop is on the 192.xxx.xxx.xxx...
by CalS201
Tue Jun 12, 2018 6:15 pm
Forum: Broadcasts and Conferences
Topic: Ready to smash the Teradek Vidiu; alternatives?
Replies: 40
Views: 8520

Re: Ready to smash the Teradek Vidiu; alternatives?

mawhiteley wrote: Given this [successfull] home network test, it appears the brain dead behavior of the vidius is related to the network at the stake center. We have the IP address correct, 1) We pull it from the front panel interface, 2) I can ping it, 3) the Vidiu icon backdrop loads in the brows...
by CalS201
Mon Jun 11, 2018 3:09 pm
Forum: Broadcasts and Conferences
Topic: Ready to smash the Teradek Vidiu; alternatives?
Replies: 40
Views: 8520

Re: Ready to smash the Teradek Vidiu; alternatives?

mawhiteley wrote: The vidiu goes brain dead a lot, nothing to do with internet bandwidth. It's on our LAN, plugged into the same switch as the computer trying to command/control it. Did you add a switch to the network? Is it just a switch or a router/switch? Are you connected through RJ45 in chapel...
by CalS201
Mon Jun 11, 2018 12:02 pm
Forum: Broadcasts and Conferences
Topic: Ready to smash the Teradek Vidiu; alternatives?
Replies: 40
Views: 8520

Re: Ready to smash the Teradek Vidiu; alternatives?

mawhiteley wrote: On too many occasions we've left hundreds of members stranded in buildings without the broadcast ( even though previous tests are successful ). All APs are disabled in both the transmitting and receiving locations, but inevitably the broadcast (1.1 Mbps) will drop right before con...
by CalS201
Thu Apr 19, 2018 1:07 pm
Forum: Webcasting
Topic: Can't setup 2 receive PC's in 1 building?
Replies: 17
Views: 2565

Re: Can't setup 2 receive PC's in 1 building?

Instead of setting up laptops in the RS and Primary rooms you could "extend" the HDMI signal from the laptop in the chapel using one HDBitT transmitter and two HDBitT receivers. The units are inexpensive and work over existing IP LAN wiring and switches. https://www.amazon.com/gofanco-395f...
by CalS201
Mon Mar 19, 2018 9:21 am
Forum: Webcasting
Topic: PTZ camera control using IP
Replies: 11
Views: 4709

Re: PTZ camera control using IP

Here is the missing attachment
by CalS201
Sun Mar 18, 2018 5:55 pm
Forum: Webcasting
Topic: PTZ camera control using IP
Replies: 11
Views: 4709

Re: PTZ camera control using IP

Evidently the forum has reached a limit on attachments. I get this error message "Sorry, the board attachment quota has been reached."

Go to advanced search