Too bad. That was a nice feature.nmecantwin73 wrote:No, there is not a way to reboot the firewall in TM. You would need to be on-site and physically disconnect the power to the firewall.
I don't have a tester. I leave those things to the FM Group. They have always come through so far.Mikerowaved wrote:THIS
Yes. Everything is in TM except for the IP Address. I can even turn it on and off. Or appear to. But the AP is not working. When I disable the rest of the APs and leave this one active, there is no WiFi service.Biggles wrote:Another thought, can you see the MAC address, in TM, for the faulty AP?
Oddly, the light is green until I walk into the area and then turns blue as my phone connects. The light on the Ethernet cable is flashing indicating traffic. But there is no connection.
I have turned the problem back to the FM Group. They were the ones who asked me to look into it in the first place. They replaced the four APs and then noticed in TM that one of the IP addresses was missing. They are two hours away, so I like to help them when I can. It pays big dividends when I am able to save them a trip or solve some of the more simple problems for them.
I suspect they really need to run a new wire and have told them so. We will see what they are able to determine.