Meraki switch "dormant" but some devices on it are still working
-
genius_ford
- New Member
- Posts: 1
- Joined: Sun Sep 01, 2024 8:29 am
Meraki switch "dormant" but some devices on it are still working
We have a set of 4 Meraki MS120 managed switches in our stake center. One of them in CNM shows a status of "dormant," but the devices connected to it (APs, at least, I haven't verified the computers connected to it) are still working fine. However, if I try to connect a new wired network device (the Ethernet port on the pulpit is connected to this switch, and I'm trying to connect a device to it for streaming), it doesn't connect. I've power-cycled the switch a few times but there's no change. I'm a little hesitant to do a factory reset on a Saturday, but might come during the week to do so. Any suggestions other than a factory reset?
-
russellhltn
- Community Administrator
- Posts: 35304
- Joined: Sat Jan 20, 2007 2:53 pm
- Location: U.S.
Re: Meraki switch "dormant" but some devices on it are still working
Make sure the ports are set correctly. Perhaps the port the pulpit is connected to is "disabled". You could try power cycling it.
Have you searched the Help Center? Try doing a Google search and adding "site:churchofjesuschrist.org/help" to the search criteria.
So we can better help you, please edit your Profile to include your general location.
So we can better help you, please edit your Profile to include your general location.