Is there any possibility at some point for an article (maybe along the lines of the article about the Distributed Nagios eXecutor) about the data model of the new FamilySearch?
Knowing a little of the behind-the-scenes stuff can help make better sense and promote better use of the front-end stuff. For example, for one of my ancestor families Pedigree mode shows one group of parents for the couple, while Family Group Record mode shows a different group of parents. When I submitted it as an issue, I got a reply that while common sense might say the two modes should display the same group of parents, the difference is by design. If I knew a little more about the data model and in what way this difference is designed in, I could make better use of the system.
New FamilySearch data model
-
rmrichesjr
- Community Moderators
- Posts: 4210
- Joined: Thu Jan 25, 2007 11:32 am
- Location: Dundee, Oregon, USA
-
WelchTC
- Senior Member
- Posts: 2085
- Joined: Wed Sep 06, 2006 8:51 am
- Location: Kaysville, UT, USA
-
rmrichesjr
- Community Moderators
- Posts: 4210
- Joined: Thu Jan 25, 2007 11:32 am
- Location: Dundee, Oregon, USA