I need the specs from a Teradek Vidiu Pro power supply, please

Discussions around receiving, originating, and holding Church broadcasts and conferences in meetinghouses including schedules, setup, equipment, and support.
dbaresrc
New Member
Posts: 48
Joined: Sun Jan 13, 2013 12:03 pm

I need the specs from a Teradek Vidiu Pro power supply, please

Post by dbaresrc »

If anyone has a V Pro available, can you tell me the specs on the power supply?? Our Vidiu died and we got a used V Pro. Unfortunately, there was no power supply with it. The manual is a bit . . . . . casual . . . . . . with the power supply specs. All they say is 6-18 volts 4.5 to 10 watts. I'm trying to figure out what to buy on Ama as a replacement. I assume I'm safe with a 12 v 1 amp power supply but I'm not 100% sure. Is it center positive or negative as well.

Thanks for the help.

Carlton
lajackson
Community Moderators
Posts: 11795
Joined: Mon Mar 17, 2008 10:27 pm
Location: US

Re: I need the specs from a Teradek Vidiu Pro power supply, please

Post by lajackson »

dbaresrc wrote:. . . can you tell me the specs on the power supply?
Use the old power supply. According to a (four-year-old) Teradek Article, they use the same power supply and cable. Polarity is center tip positive and outer ring ground.
CalS201
Member
Posts: 166
Joined: Fri Jan 28, 2011 3:59 pm
Location: Herriman, UT

Re: I need the specs from a Teradek Vidiu Pro power supply, please

Post by CalS201 »

lajackson wrote:
dbaresrc wrote:. . . can you tell me the specs on the power supply?
Use the old power supply. According to a (four-year-old) Teradek Article, they use the same power supply and cable. Polarity is center tip positive and outer ring ground.
Per the Specs in the User Manual:
http://cdn.teradek.com/Public/VidiUPro/ ... 3_1117.pdf

VidiU is 6-12VDC, 1.5A max, 3.0W nominal, 10W when charging
VidiU Pro is 6-18VDC, 1.5A max, 4.5W nominal, 10W when charging

You can use a 6V / 1.5A , or 12V/1.0A power supply.
dbaresrc
New Member
Posts: 48
Joined: Sun Jan 13, 2013 12:03 pm

Re: I need the specs from a Teradek Vidiu Pro power supply, please

Post by dbaresrc »

Thanks for the replies. I found the same docs after posting my message.

Return to “Broadcasts and Conferences”